Thingiverse
Lasercut Infinity Cube
von derfer
18
Downloads
6
Likes
0
Makes
I saw a picture of one of these and wanted to have a go at making my own.Makes a cube approximately 90mm by 90mm, but could easily be adapted to make one bigger or smaller.
Laser cut from c. 3mm ply board (designed for 2.7mm thick ply as that was the average thickness of the stock I used) and glued together.
Cut out six sets of the plans, glue each set together to make each side (glue three with the peg facing outwards and three with the peg facing inwards - as per photo). Glue the six sides together.
Laser cut from c. 3mm ply board (designed for 2.7mm thick ply as that was the average thickness of the stock I used) and glued together.
Cut out six sets of the plans, glue each set together to make each side (glue three with the peg facing outwards and three with the peg facing inwards - as per photo). Glue the six sides together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
