Thingiverse
Latch Lock
von anmael
1.9k
Downloads
1.5k
Likes
6
Makes
This is a simple and very easy to print and customize latch lock.
Just print:
2x Base
2x Top
1x Hook
Additionally you will need two screws (length and diameter depends on on your parameters, works well with m4x10 at the current settings).
Assembly is pretty self-explanatory, just screws the tops to the two bases (slide the hook in one of them before)
Each piece is very simple to print and requires no support.
The concept is simple and the lock works well, and it is fairly customizable.
Just print:
2x Base
2x Top
1x Hook
Additionally you will need two screws (length and diameter depends on on your parameters, works well with m4x10 at the current settings).
Assembly is pretty self-explanatory, just screws the tops to the two bases (slide the hook in one of them before)
Each piece is very simple to print and requires no support.
The concept is simple and the lock works well, and it is fairly customizable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
