Thingiverse
LattePanda Centered Display Stand Casing AddOn
von jmoontech
2
Downloads
0
Likes
0
Makes
Case for LattePanda Centered Display Stand.
Based on this design https://www.thingiverse.com/thing:1683968 but improved by using thicker walls and pillars for better protection of the Latte Panda Mini PC.
You will also need:
1x LattePanda Centered Display Stand (https://www.thingiverse.com/thing:1621244)
4x M3 nuts and M3x30mm screws.
1x 7" 1024 x 600 IPS Display for LattePanda (https://roborium.com/LattePanda/7-inch-1024-600-ips-display-for-lattepanda)
1x 7" Capacitive Touch Panel Overlay for IPS Display (https://roborium.com/LattePanda/7-inch-capacitive-touch-panel-overlay-lattepanda-ips-display)
and
1x LattePanda Mini PC (https://roborium.com/lattepanda)
Print with supports under the wire protection notch on the side. No other supports needed.
Infill: 15% or higher
Based on this design https://www.thingiverse.com/thing:1683968 but improved by using thicker walls and pillars for better protection of the Latte Panda Mini PC.
You will also need:
1x LattePanda Centered Display Stand (https://www.thingiverse.com/thing:1621244)
4x M3 nuts and M3x30mm screws.
1x 7" 1024 x 600 IPS Display for LattePanda (https://roborium.com/LattePanda/7-inch-1024-600-ips-display-for-lattepanda)
1x 7" Capacitive Touch Panel Overlay for IPS Display (https://roborium.com/LattePanda/7-inch-capacitive-touch-panel-overlay-lattepanda-ips-display)
and
1x LattePanda Mini PC (https://roborium.com/lattepanda)
Print with supports under the wire protection notch on the side. No other supports needed.
Infill: 15% or higher
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!