Thingiverse
Lav Mic Custom Keypad Stand
door Nerys
4
Downloads
10
Likes
0
Makes
Made a custom stand for my lav mic and programmable keypad to be mostly vase mode printable. worked out very nice. if you get the same keypad and mic i got it will fit.
Lav Mic Used https://amzn.to/3agFKTp
Programmable Keypad https://amzn.to/2PG7w3L
The keypad I got seems to not be available here is a similar one
https://amzn.to/3ckmw0R
I DO NOT know if its the same dimensions or not!!
Slicing instructions
I used 3 Processes to print this.
process one 0 to 0.48mm 3 perimeters 2 bottom layers 0.94 extrusion (flow rate)
process two 0.48 to just under the "bell housing" for the mic
Vase mode 1.5 extrusion multiplier (flow rate)
process three to completion 3 perimeters 25% infill 3 top 3 bottom layers 0.94 extrusion (flow rate)
Lav Mic Used https://amzn.to/3agFKTp
Programmable Keypad https://amzn.to/2PG7w3L
The keypad I got seems to not be available here is a similar one
https://amzn.to/3ckmw0R
I DO NOT know if its the same dimensions or not!!
Slicing instructions
I used 3 Processes to print this.
process one 0 to 0.48mm 3 perimeters 2 bottom layers 0.94 extrusion (flow rate)
process two 0.48 to just under the "bell housing" for the mic
Vase mode 1.5 extrusion multiplier (flow rate)
process three to completion 3 perimeters 25% infill 3 top 3 bottom layers 0.94 extrusion (flow rate)
Nerys publiceert ook op
42 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!