Lawnmower Handle

This handle has been designed to repair a broken one on my Viking ME443 lawnmower.

The full replacement handle is available for 20€ but I found it more eco-friendly to replace only needed part :) and it was a good opportunity to try out the new Freecad version !

To repair my handle, I followed these steps :
- make sure you have 2 M3 screws and 2 M3 break nuts on hand.
- dismount the old handle case from your landmower. on mine I had to cut off the top case screw and replace it with a larger one.
- print poignee-axe-v13.stl
- print poignee-gabarit-v13.stl
- make sure the part fits in the handle case
- cut your old handle as shown on picture
- use the guide (poignee-gabarit-v9) to drill holes in your old handle
- put two M3 screws 15mm length and M3 break nuts to assemble the old handle with the
poignee-axe-v13

That's it ! it worked for me at least, hope it will work for you.

The freecad file is far from being perfect but it works :)
Even if I have drawn the full h