Layer and Height Test

I've recieved a few messages lately asking about calibration for thinner, and taller models. Most of these messages involve the same recurring issues. The first few layers being ok, then things go awry the taller the model gets. This is a very simple test that i made simply from primitives, but it gets the job done quick and simple. Run your favorite first layer test first, and make sure you're getting a perfect sheet. Then, move on to this. No rocket science or 3 hour print here. You're looking for a nice top finish on the square. A perfect shape and slope to upward facing cone. If you knock the upside down cone off the support, or knock over the cylinder. Start fine tuning flow rate, dynamic flow volume, and in rare cases, your z offset in the machine gcode. if you can pass this test, you're printer is ready for most models you throw at it.Hope this helps anyone who is having issues, feel free to reach out if you have any questions. Throw this one a like or boost if i