Layer comparer and bridge tester

This gizmo is for seeing how different layer thicknesses compare, and getting an indication of bridging performance.

It has a loop to hang the samples on a peg board, so you can compare filaments easily.

Use the customiser to set the number of rectangles (frames) and your height increments (layer_step_height) as well as other parameters such as frame dimensions and label text. Or just use the default settings.

e.g. If you set frames = 4 and layer_step_height = 0.2, the frame layers will be created as 0.2, 0.4, 0.6 and 0.8mm

Check that in your slicer settings your first layer height is