Thingiverse
LC100-A LC meter case
door onetransistor
8
Downloads
9
Likes
0
Makes
An enclosure for the LC100-A LC meter.
Buttons should be printed rotated as shown to allow smooth sliding in the case cutout.
There is also a cover for the DC jack because this device requires 5 V and I might power it from 12 V or more through that. I only use USB connector.
The base PCB standoffs and the two top screws holding the LCD need to be removed (first remove base standoffs, insert in bottom half of the case, put the new screws, and then remove LCD top screws).
6 extra M3 screws are needed (see photos).
For the text, I applied spray paint over front panel, then cleaned it with solvent and polished the surface (it is not my best result).
Buttons should be printed rotated as shown to allow smooth sliding in the case cutout.
There is also a cover for the DC jack because this device requires 5 V and I might power it from 12 V or more through that. I only use USB connector.
The base PCB standoffs and the two top screws holding the LCD need to be removed (first remove base standoffs, insert in bottom half of the case, put the new screws, and then remove LCD top screws).
6 extra M3 screws are needed (see photos).
For the text, I applied spray paint over front panel, then cleaned it with solvent and polished the surface (it is not my best result).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
