Thingiverse
LCD 2004A i2C Case
by jmparatte
27
Downloads
21
Likes
0
Makes
The case height is 18mm, 22mm with the display module installed.
The 2 parts top and bottom can be glued or screwed.
The max diameter screw is 3mm, limited by the LCD module.
All holes are 2mm diameter and must be adjusted for appropriate usage.
The holes spacings are 55 x 93 mm.
A small notch signals the GND pin of i2C connector.
A small hole on the bottom indicates where is the potentiometer to adjust the LCD contrast.
The 2 parts top and bottom can be glued or screwed.
The max diameter screw is 3mm, limited by the LCD module.
All holes are 2mm diameter and must be adjusted for appropriate usage.
The holes spacings are 55 x 93 mm.
A small notch signals the GND pin of i2C connector.
A small hole on the bottom indicates where is the potentiometer to adjust the LCD contrast.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!