LCR Meter Case (and modelled components)

Finally printed this version - slight fiddling here and there for better clearances (buttons run close to each other). Also added a 0.4mm thick cover for the buttons area as, to get a better face, save using supports and reduce print time, I printed the lid face down. The buttons recess was therefore printed on support material and not the glass bed. It looked 'rough', even more so when I sanded it a bit . . . .

My wife said 'ugh, I don't like that', so I covered it!

The cover is an optional extra printable part - included for if you want it.

There's a barely noticeable chamfer around the buttons on the upper face - the upper is also how Thingiverse displays it..

______________________________________________________________________

EDIT: 18 Jun 2018 - V5_1_Final Base uploaded (old removed), Clearance issues with 'Anti-rotation' bit.
SHOULD HAVE GONE FOR SQUARE BUTTONS!!!

EDIT: 17 Jun 2018

V5 (and final, maybe) uploaded. Changed back to the original staggered spl