Thingiverse
Le beautiful touch
von Thunderhowl
16
Downloads
9
Likes
0
Makes
A way to hide a little the BLTouch (the ugly yellow tape)
use the screws that comes with the bltouch (ver 3.1)
use the original screws in the printer
Only one part, u can calibrate the bltouch via software, no need for extra steps :)
The cover is a little shorter than the original to avoid heat.
the offset of the probe is a little different from Waggster mod u will have to use this commands in a console to correct it (im using octoprint)
M851 X36 Y-22
M500
use the screws that comes with the bltouch (ver 3.1)
use the original screws in the printer
Only one part, u can calibrate the bltouch via software, no need for extra steps :)
The cover is a little shorter than the original to avoid heat.
the offset of the probe is a little different from Waggster mod u will have to use this commands in a console to correct it (im using octoprint)
M851 X36 Y-22
M500
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
