Leapfrog Creatr HS spool adapter

This is an adapter for 52mm center hole spools. I found that the single 16,5mm pin in the middle let the spool shift when extruding, this keeps the spool in the middle. The base rests on the bottom bearing plate so it will still use that to spin. Center hole is made as 17,5mm and outside diameter is 51,5mm. This allows for some deviation in printer setups but just scale up or down if the printer needs it. I also made a I and II slot in the top so you may see when it is spinning, if you want to indicate it for some reason.