Thingiverse
Leapfrog Creatr nozzle cooling system V2
door zabana
69
Downloads
105
Likes
11
Makes
Hi all!
Because certain issues when printing bridges and problematic areas with my Leapfrog Creatr I decided to design a colling system for the printerôs nozzle.
An add on is the increased printing speed.
I needed about 6 versions (someones with sub-versions) but finally Iôm happy with this final design.
This design can use a 50x50mm fan or a 60x60mm one, Iôll suggest a 50x50mm one (easy to find over ebay, I bought this one "Delta AUB0512HB 50x50x15mm 5015 DC 12V 0.15A Brushless Fan 2-pin 2510 Connector"), but there is a choice to use a 60x60mm kind, but it will crash a little with the right rear stepper.
I also added in both sides holes to insert a couple of 5mm leds so we can see better the printing area :D
Because certain issues when printing bridges and problematic areas with my Leapfrog Creatr I decided to design a colling system for the printerôs nozzle.
An add on is the increased printing speed.
I needed about 6 versions (someones with sub-versions) but finally Iôm happy with this final design.
This design can use a 50x50mm fan or a 60x60mm one, Iôll suggest a 50x50mm one (easy to find over ebay, I bought this one "Delta AUB0512HB 50x50x15mm 5015 DC 12V 0.15A Brushless Fan 2-pin 2510 Connector"), but there is a choice to use a 60x60mm kind, but it will crash a little with the right rear stepper.
I also added in both sides holes to insert a couple of 5mm leds so we can see better the printing area :D
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
