Leather Craft Table Stitching Pony

This is a sewing pony/clamp for leathercraft. Some assembly required.

Pending update:
Slim profile set

Update:
12/06/20: ClampTop update to V3, requires 2x ClampNut for better construction. 20cm clearance clamp file updated. rotate 45 degrees to fit on ender 3 build plate.
04/06/20: V2 set of screws uploaded. V2 screws allow you to print them flat with less infill and higher strength. Print them along X or Y axis, do not rotate.
03/06/20: New version of ClampBot uploaded, please print the V2 ClampBot with Strong nut laying flat. The V2 version will be much stronger while reducing support required. Previous version removed to avoid confusion.

02/06/20: Oh no I made a booboo. Updated V2 clamp top to allow full folding, original update is obsolete now. High tolerance file will be updated later. Look out for V2. Note: 5mm extension is added to the pivot point.

01/06/20: Please use support blocker in Cura for ClampTop to make the hinge print at higher wall count or infill to