LED Air Rocket Adapter

This is an easy to print adapter to add LED's to your compressed air rockets. Allows you to launch at dusk or at night for a rocket light show - plus helps you find it in the dark...
Fits air rockets based on a 1/2" pipe launch tube. Works well with Air Rocket Works compressed air rocket parts: www.airrocketworks.com
1. Print all 3 parts, Lower LED Housing.STL, Upper LED Housing.STL and LED Bend Tool.STL
2. Test threads and adjust printer settings if needed.
3. Locate (3) 5mm LED's and 2 AG13/LR44 batteries.
4. Bend and trim LED legs using the 3D printed tool. Using the multi-image above, start in the upper left image by orienting the LED with the short leg (adjacent to the flat on the LED) near the top
5. Bend the long LED leg straight down
6. Bend the long LED leg to the right to fit in the groove
7. Bend the upper LED leg to fit in the upper groove
8. Mark the LED legs between the two arrowheads
9. Remove and trim the LED legs, then double check length and bends in the