Thingiverse
LED Balloon Insert
por ShuttleSpace
12
Descargas
10
Likes
0
Makes
An insert to put a DIP type LED inside a balloon and allow it to be filled and tied off easily.
Has recess in the bottom for a 2X10MM magnet.
This works with the throwie kit that we sell at LilyLEDs
http://www.lilyleds.com/Products/113/LED-Throwies
The grooves are for tie-off's or elastics.
It will need a plug for inside the bottom or could put some thin tape or something over the magnet before inserting it to give a good seal.
Could also be used as a thrust or propellant device for balloon powered vehicles.
I printed one on a Makerbot and it needs to be upscaled maybe 3-4% for the pieces to fit in.
It did print better horizontally,
Edit this in the browser in its original location on Orchard:
https://3dorchard.com/app/single/58704cac3718e40c0498d0b1/58e8f3121535440c7c94e12e
Has recess in the bottom for a 2X10MM magnet.
This works with the throwie kit that we sell at LilyLEDs
http://www.lilyleds.com/Products/113/LED-Throwies
The grooves are for tie-off's or elastics.
It will need a plug for inside the bottom or could put some thin tape or something over the magnet before inserting it to give a good seal.
Could also be used as a thrust or propellant device for balloon powered vehicles.
I printed one on a Makerbot and it needs to be upscaled maybe 3-4% for the pieces to fit in.
It did print better horizontally,
Edit this in the browser in its original location on Orchard:
https://3dorchard.com/app/single/58704cac3718e40c0498d0b1/58e8f3121535440c7c94e12e
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
