Led bar - CR10

This thing is made from:
* Clip-on LED Bar & Diffuser at https://www.thingiverse.com/thing:3284272
* 2020 Cable Clips at https://www.thingiverse.com/thing:2673266

I've made measurements for the Creality CR10 & CR10-S.
To make this led bar, you need to print:

### Front led bar

* 2 "Front led bar" without support,
* 2 "Front diffuser bar" without support (in transparant plastic for a best result),
* 4 "Bar clip" with support.

### Rear led bar

* 2 "Rear led bar" without support,
* 2 "Rear diffuser bar" without support (in transparant plastic for a best result),
* 4 "Bar clip" with support.

Enjoy and good prints!