Thingiverse
Led extrusion 45° angle mount
von Maweur
0
Downloads
0
Likes
0
Makes
For 2020 profile
LED Aluminum Extrusion Profile 12mm in width.
Printed in PETG but if you use it on open frame project PLA is fine too.
Uses single M3 screw 8mm or 10 mm with more washers.
It have hole for allen key to screw in the bolt straight.
LED profile is supposed to just click in.
LED Aluminum Extrusion Profile 12mm in width.
Printed in PETG but if you use it on open frame project PLA is fine too.
Uses single M3 screw 8mm or 10 mm with more washers.
It have hole for allen key to screw in the bolt straight.
LED profile is supposed to just click in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!