Thingiverse
LED Flashlight Desk Holder
von TACAMO
2
Downloads
0
Likes
0
Makes
Made this to hold my flashlights on the edge of my desk. The clamp is 19mm.
I used a little double-sided tape to keep it in place. The cut out for the flashlight is 35mm.
Added another with a 6mm hole done the center to run a bolt through for better mounting.
I used a little double-sided tape to keep it in place. The cut out for the flashlight is 35mm.
Added another with a 6mm hole done the center to run a bolt through for better mounting.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
