LED fluorescent lamp socket

!!!!ATTENTION!!!!ATTENTION!!!!ATTENTION!!!!

! ELECTRICITY CAN DO DAMAGE OR WORST CASE KILL !

This is a holder for LED tubes. IT CAN NOT be used for FLUORESCENT LAMPS.


1) Pic. 2. Take two connector out of a terminal block connector. It doesn’t have to be a ceramic one.

2) pic. 3 an 4. Strip the insulation about 40 mm, and the inner insulation and about 6 mm. I prefer to put tube terminals on, but not a requirement.

3) pic. 5 and 6. Insert the conductors through the socket and mount the connector as shown in the picture.

4) Pic. 7 and 8. Connect the tubes to the connector. Make sure to connect the right end, here the tubes are marked with “AC INPUT”. Remember to turn tubes so that it lights the right way.

5) Pic. 9, 10 and 11. Insert the cord so that it covers the strain relief and then place the cap as shown in the picture.

6) pic. 12 and 1. Now screw on the light fixture on the wall, ceiling or where you need it. You can now connect it to a power source.