Thingiverse
LED Indicator Holder
door jpcw
9
Downloads
14
Likes
0
Makes
This is an LED indicator holder that clips onto the side mirrors of a motorbike.
On my motorbike I have to keep looking down to see if my indicators are on so I decided to wire some LED’s to my indicators and stick them to the mirrors. The problem was that nothing stuck to the chrome very well. This is where the clips come in. They still need some super glue to stop them slipping off but because the clips take most of the strain the clue seems to hold well enough now.
As mirrors are different shapes you will probably need to tweak the design to get them to fit.
The LED’s are standard 2V orange 20ma and are connected to the indicators via a 560 Ohm resistor.
On my motorbike I have to keep looking down to see if my indicators are on so I decided to wire some LED’s to my indicators and stick them to the mirrors. The problem was that nothing stuck to the chrome very well. This is where the clips come in. They still need some super glue to stop them slipping off but because the clips take most of the strain the clue seems to hold well enough now.
As mirrors are different shapes you will probably need to tweak the design to get them to fit.
The LED’s are standard 2V orange 20ma and are connected to the indicators via a 560 Ohm resistor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
