Thingiverse
LED Lamp
door TorbenLiltorpMoller
2
Downloads
0
Likes
0
Makes
This is an LED lamp for my office.
Connection parts are PLA and the connection rods are 8 mm aluminium rods.
Power is supplied through one of the balls, run through the rods to the front ball where there is a switch. And then run trhough the two long roda to the LED modules in the top.
Light is from 4 x 1 Watt LED's using 300 mA at around 13 Volt.
LED is monthed on the heatsink to disipate the heat.
Connection parts are PLA and the connection rods are 8 mm aluminium rods.
Power is supplied through one of the balls, run through the rods to the front ball where there is a switch. And then run trhough the two long roda to the LED modules in the top.
Light is from 4 x 1 Watt LED's using 300 mA at around 13 Volt.
LED is monthed on the heatsink to disipate the heat.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
