Thingiverse
LED light for 3D printer
por 7eggert
9
Descargas
9
Likes
0
Makes
LED light for the heatbed
4 LED, mounted above the heatbed on my Prusa i3 A8 using existing screw holes.
Warning, the screws must be level with the surface, otherwise the extruder will be blocked. I shortened 2 30 mm screws to fit.
I'm using 2 white LED for each side with a 470 Ohm resistor (12 V). It's bright enough to not need additional light for casually looking at the print, but it can't - off cause - reach the area right below the print head.
The internal support wasn't easy to remove. I had to use a drill.
The error in the STL for the right side was buried in the printing process, but you might like to mirror the left light instead.
4 LED, mounted above the heatbed on my Prusa i3 A8 using existing screw holes.
Warning, the screws must be level with the surface, otherwise the extruder will be blocked. I shortened 2 30 mm screws to fit.
I'm using 2 white LED for each side with a 470 Ohm resistor (12 V). It's bright enough to not need additional light for casually looking at the print, but it can't - off cause - reach the area right below the print head.
The internal support wasn't easy to remove. I had to use a drill.
The error in the STL for the right side was buried in the printing process, but you might like to mirror the left light instead.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!