LED mount holder for Maker Select V2

I really liked the LED mount by Rexipus,
https://www.thingiverse.com/thing:1880015
But it was a little too big. I remade the tray the LED strip sits in to hold only half of it. It will still fit in his mounting bracket.

I ordered the same LED strips off EBAY, https://www.ebay.com/itm/301032417732 and then just cut the light panel down the middle legnth wise by scoring it about 10 times with a razor and then snapping it in two. The LEDs will still work and you end up with a panel half the size.

I used an M3 35mm screw and nut for the hinge and then M3 12mm screw and nut x2 to bolt it to the printer.

You need to have a rear mounted cooler fan like the Cii cooler (thats what I use)
https://www.thingiverse.com/thing:2004629

Just wire the LED up to the extruder cooling fan and you are good to go. Now I no longer have to use a flash light to see the print!