LED Planter - V1

*edit* The LED housing sagged bad after a month so here's my attempt #2 at managing the heat and sag
https://www.thingiverse.com/thing:4983577

A planter I designed complete with drain holes and a catch pan! Can be powered by the Ender 3 24v power supply if using 24v LEDs. Add a single pole light switch for less than a dollar from Walmart and you can use my box design for that as well.

I made this little planter to house a basil plant, its a snug fit but it should all go together.
I used white 24v LEDS linked below and the LED housing itself is designed to hold 3 rows and be slightly ventilated above but the part does tend to get warm and after about a month or two you'll notice a slight sag in the led housing. The LED strip can only be cut in rows of 6 leds so the led housing is designed to hold 3 of these wired parallel and then 2 wires can be led down the rods holding the light.

No special way to get wires through the tubes I just wiggled them through but i'm sure a long t