Thingiverse
Led Pole for ender 5
door Hrumque
1
Downloads
1
Likes
0
Makes
Led posts for corners, for Ender5 and similar.
In the base, the hole for the M4 screw, the thread is included in the model - but in order for it to screw in well, it should be threaded again after printing.
The height of the post is 60mm, which is enough for a piece of LED strip, COB LED, or a WS2812 strip or a tipical board with 8 WS LEDs, etc. At the bottom there are holes for the wires, and leds on all 4 poles - can be connected pararell (even 4 WS2812 strips - DI input pin connected together, they light efect will be identical)
It prints well when there are 4 posts on the table close to each other - there should be no problem with adhesion.
In the base, the hole for the M4 screw, the thread is included in the model - but in order for it to screw in well, it should be threaded again after printing.
The height of the post is 60mm, which is enough for a piece of LED strip, COB LED, or a WS2812 strip or a tipical board with 8 WS LEDs, etc. At the bottom there are holes for the wires, and leds on all 4 poles - can be connected pararell (even 4 WS2812 strips - DI input pin connected together, they light efect will be identical)
It prints well when there are 4 posts on the table close to each other - there should be no problem with adhesion.
Hrumque publiceert ook op
131 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!