LED skull Halloween

Welcome to my LED skull Halloween model- snappy title eh!These models have light up eyes using only 2x 5mm led’s and 1 cr2032 battery. Be carful with higher shrinkage filament as this might make the led and battery fit tricky. No soldering is required you simply install the led’s, then bend the legs to fit either side of the battery. This model comes in two sizes large =14x9x6 (cm)Small = 9x6x3.5 (cm)This is a cool model that can be used for lots of things. It will attach to you car, bike, scooter desk etc It is light enough to be wall mounted with blu-tack, tape etc. There is provision for both vertical and horizontal mounting with cable tiesNote the print time is not as quick as it could be but I have used variable layer heights to give a good looking print. I don’t recommend going to a uniform layer height is this will give you a very poor surface. There are some instructions added below Boost MeBoosts are a lovely way to say you like the model, sharing is caring