Thingiverse
LED Strip Clips
par PMishra
1
Téléchargements
3
Likes
0
Makes
I made these LED Strip Clips for my Ender 3D Printer Enclosure, these may not fit yours so make sure you do your research and take measurements before you print these. My enclosure support beams were ~8.24mm OD, the LED strip I used is 10mm Wide and 2.75mm thick.
These clips will 'clip' onto the support beams inside the enclosure and the square part with a bit of overhang will allow the LED to go in easily but not fall out. It's a snug fit
These clips will 'clip' onto the support beams inside the enclosure and the square part with a bit of overhang will allow the LED to go in easily but not fall out. It's a snug fit
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
