Thingiverse
LED Strip Holder v2
by Grantisimo
31
Downloads
21
Likes
0
Makes
Version 2 of my LED strip holder. Version 1 had some minor warping on the ends, due to the heat of the LEDs and the PLA I printed them in. I remodeled the walls to be a little thicker, and moved the screws closer to the ends.
The tracks have mounting holes for #6 screws, are 150 mm long and a little bit more than 14 mm wide. The inside track is ~10 mm wide and can accommodate most standard LED strips.
I've also updated the alignment jig to fit the new width.
The tracks have mounting holes for #6 screws, are 150 mm long and a little bit more than 14 mm wide. The inside track is ~10 mm wide and can accommodate most standard LED strips.
I've also updated the alignment jig to fit the new width.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
