LED strip holder with optional cable holder

Printing:
Small Layer Height
No support needed

; Update 19.01.21
Depending on what bed you use, they might fall over or get stuck on the print head, causing the same result. You have multiple options:
Experiment with orientation. For me, they will print, if you are facing the front and they will not print if they are sideways. I can print up to 6 in one go if I put one behind the other. They wont print if I put them next to each other. If nothing helps, use a large brim. Removing all of these annoying brims can be pretty annoying if you need many of these.


If you print more than 1 of these at once, consider turning Z-Hop on, because sometimes the nozzle rips them off while traveling to the next one.

Description:
This is a holder for an ip20 led-strip. Those holders are supposed to be hotglued to a straight surface, as I am unable to use screws and I do not want to use the adhesive tape on the back of the strip because they always fall off after a couple of weeks, no mat