LED Strip light clip

This is a small clip for a LED Strip light. The ones the strip came with were too few and a bit fragile.I remade the model tougher and thicker. The image shows the original on the left, PETG Translucent in the middle and PLA Matt on the right. It's pretty solid and printed at an angle to increase strength further as the layers cross stress points but the support needed is a bit difficult to get off. Just under 2g filament per clip step them up as you need them. Be warned they take ages to print in PETG Translucent as it's set to run slow and steady to get the clearest result.