LED Strip light for Ender

Based around a purchased LED strip light from Menards, SKU# 3472308

You will need to tear the light down. This will require you to unsolder the wires from the lights circuit board and resoldering them. Also you will need to trim the opaque panel slightly. I did this with a straight edge and Exacto knife.

You will need some purchased hardware. (4) M4 nuts and (4) M4 x 12mm long hex hed screws. To hold the triangular end caps on re-use the (4) little screws from the original light.

The light has two output levels. The high is pretty nice but ultimately it will not light up under the extruder. It does provide enough light to see what is happening though.

I have included the Invenotr files should you wish to alter them.