Thingiverse
LED Tape Clip
by tsh2
223
Downloads
141
Likes
0
Makes
Small fixing clip for an LED light strip. Mount with M3x12 or M3x16 wood screw. Its very thin, so take care not to over-tighten.
Print with 100% infill, 1 wall thick. On edge, with support if necessary for the screw hole.
The 'pan' variants are for a flat-headded screw, the normal ones for countersunk.
The double sided ones need cleaning up. Depending on your slicer, they may print OK, but check first.
Print with 100% infill, 1 wall thick. On edge, with support if necessary for the screw hole.
The 'pan' variants are for a flat-headded screw, the normal ones for countersunk.
The double sided ones need cleaning up. Depending on your slicer, they may print OK, but check first.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
