Thingiverse
Led Track Holder
door Goncermor
0
Downloads
2
Likes
0
Makes
This part is designed to mount an LED aluminum track without drilling or screwing.
It uses double-sided tape, but the tape is applied to this holder, not directly to the aluminum track.
The heat from the LED strip caused the double-sided tape to warm up and peel off.
With this part, the tape is isolated from the aluminum track, preventing it from peeling off due to heat.
### Print Settings
Supports: Yes
It uses double-sided tape, but the tape is applied to this holder, not directly to the aluminum track.
The heat from the LED strip caused the double-sided tape to warm up and peel off.
With this part, the tape is isolated from the aluminum track, preventing it from peeling off due to heat.
### Print Settings
Supports: Yes
Goncermor publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
