Lee Single Stage Kicker V2

This is a remix of the original Case Flipper by buckeye43210.

Update: I adjusted the slot to better fit on the primer arm pin inside the press shaft.
If you have already printed the previous version and it is falling out, you can adjust the slot with a small file to match the shape of the slot on the metal primer arm.

I lengthened the tip of the kicker by about 1/8th of an inch as it was not pushing some cases off completely.

I recommend 50% in fill or more for strength.

I designed a bullet ramp for the Lee Challenger Single Stage:

https://www.thingiverse.com/thing:4161637