Thingiverse
Lego Hood (Repaired)
door Givaneo_Arts
1
Downloads
15
Likes
0
Makes
There were thin walls on 3D_LEGO_StarWars's model that caused the model to not slice properly, so I repaired the thin walls and also reinforced the upper section of the interior of the hood.
I found that printing this upside-down with supports works best (see third photo).
I found that printing this upside-down with supports works best (see third photo).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!