Lego LightSaber

So this project is a recreation of a Lego lightsaber to as close of a 1:1 replica as I can.
There are a few parts. There are three main parts that make up the base.
The slide is a piece in which you fix the main electronics too.

the electronics you need are

- 1. Adafruit feather m0 express
- 1. 3.7 v lipo battery
- 1. Adafruit capacitive touch sensor
- 1. Led strip
- 1. small Tactile Switches

- 1. 4m heat insert
- 1. 4m flat screw
- 1. 6.5mm diameter rod (as long as you want the blade to be.
- 1. 40mm diameter hollow clear pipe.

The rod is to give rigidity to the base and also to give you something to attach the LEDs to. and inserts through ~ 1/2 the base. The top cap also fits on it.

The capacity touch holder goes 2 sides down and one other side which goes against the capacitive touch sensor to hold it in place.

There is a hole going through the sabre to thread some wires.

you do need to insert a heat insert into the end cap this will attach with a sc