Lego-like Batarang - Split

Took the [prior batarang](https://www.thingiverse.com/thing:2705822) and split it to print vertically, so it needs almost no support. There are also pin cut outs to use the same pins as for [similar figures](https://www.thingiverse.com/thing:6944244).

##### Note on Supports

I do still generate supports for this, because of the overhang on the wings. I _**also**_ use support blockers on the inside of the pin holes, as most printers should easily handle the bridging and the generated support would be difficult to remove.

##### Note on Scale

I typically print these figures at about 5X of a standard minifig, where the original model linked above is for 10X. So be cautious of the scale when printing. A basic sanity check that it fits your expected figure size may save a wasted print.