Lego Minifig Display

Inspired by [AJsRaceway's](https://www.thingiverse.com/AJsRaceway) [Minifigure Display](https://www.thingiverse.com/thing:3901517), but built from scratch.

When I saw that thing, I liked it, but wanted them to connect in the same way as normal LEGO pieces. So I put this together.

This was really tricky to print. Printed horizontally with automatic supports, it printed okay but the supports were tough to remove cleanly. Printed vertically with automatic supports would have produced a ton of support material, so I didn't try. Printing without supports of course resulted in some bits trying to print on thin air. So I created the version with built-in supports. Prints best vertically, and then you need to cut away the extra bits on all the "bottom" sides.