Thingiverse
Lego Train Magnetic Coupler
door ABalinko
16
Downloads
12
Likes
0
Makes
3D printable Lego Train Magnetic Coupler Design by Me
Note that you need a technic pin, and a 1x8mm magnet to use this, the technic pin is not part of this project.
The Magnet Holder V2 turns better up and down so I recomend that one.
The Holder V2 has a better hight differance tolerance, so It leaves a gap between the two holders, so the magnets can connect even if they are not on the same hight level.
Note that you need a technic pin, and a 1x8mm magnet to use this, the technic pin is not part of this project.
The Magnet Holder V2 turns better up and down so I recomend that one.
The Holder V2 has a better hight differance tolerance, so It leaves a gap between the two holders, so the magnets can connect even if they are not on the same hight level.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
