Thingiverse
Leica Halfcase (Hex)
von iElectronCloud
21
Downloads
27
Likes
0
Makes
Half case for the Leica M10. I had this SLS printed. You can try FDM printing this if you have good stringing control.
This will not fit film Ms (no mounting point) or non-M10 style chassis Ms (thicc-er bodies).
You will need 1/4" -20, (1/4" long) screw to mount this. McMaster part #91355A176 is what I uses. If you have one of those peakdesign bottom plate that comes with their strap you can use that same screw as well!
Not for commercial use.
This will not fit film Ms (no mounting point) or non-M10 style chassis Ms (thicc-er bodies).
You will need 1/4" -20, (1/4" long) screw to mount this. McMaster part #91355A176 is what I uses. If you have one of those peakdesign bottom plate that comes with their strap you can use that same screw as well!
Not for commercial use.
iElectronCloud veröffentlicht auch auf
12 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
