Lenovo M72E computer wall mount

Made this mount to support Lenovo small form factor computers I use at work which power flat panel TV's that we view construction plans on. I printed this at 20% infill, 3 perimeters and a solid layer every 20 layers for strength. My first attempt at 10% infill I felt was just too weak, but there have not been any failures at 10%. This is intended to be a wall mount (hence the screw holes). You will need 2 wall screws with anchors suitable for your wall and a 2" wide velcro strap to keep the computer safe and secure to the mount. Simple but effective way to hide the computer behind the screen and get it up off of a plan table where it might get damaged.

Update 04-05-2016
I re-did a couple of things on this model to better accommodate installation. The screw holes are now lined up on top of each other so that you can hit the same stud 2x. There is also a hole in the front to make screwing the bottom screw in possible. During installation, I also added a very small/thin pie