Thingiverse
Leonardo da Vinci Bridge
von LarNil
3
Downloads
4
Likes
0
Makes
Model of Leonardo da Vinci's bridge.
No use of glue. I made notches because PLA is too slippery without.
Make it as bigger or smaller by adding or subtracting sections. One section being 2 long beams and 1 cross beam.
Assembly instructions in gallery.
For a 4 section brídge you will need:
4 x long beam foot
4 x long beam
2 x cross beam 1
1 x cross beam 2
1 x cross beam 3
All combined in the plater file
For a 3 section brídge you will need:
4 x long beam foot
2 x long beam
1 x cross beam 1
1 x cross beam 2
1 x cross beam 3
No use of glue. I made notches because PLA is too slippery without.
Make it as bigger or smaller by adding or subtracting sections. One section being 2 long beams and 1 cross beam.
Assembly instructions in gallery.
For a 4 section brídge you will need:
4 x long beam foot
4 x long beam
2 x cross beam 1
1 x cross beam 2
1 x cross beam 3
All combined in the plater file
For a 3 section brídge you will need:
4 x long beam foot
2 x long beam
1 x cross beam 1
1 x cross beam 2
1 x cross beam 3
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!