Les Paul toggle switch cover, with generator

Toggle switch cover designed to replace a missing cover on a Les Paul pick-up selector switch. The dimensions are measured from an authentic Les Paul switch.I've included three print profiles with an internal diameter of 3.0mm, 3.2 mm, and 3.4mm. Because 3 was too tight, 3.4 was too loose but 3.2 was just right. So if you are unable to use the generator you have some variation to play.The original design was done in openSCAD so modification was a simple matter and these only take 10 to 30 min depending on the hot end diameter you use. My first print was 0.4mm, which was OK (pictured with the brim) but I found that the 0.2mm extrusion looks much better (pictured with no brim).I've included the code for this design so essentially you can customise it for any toggle switch.Parameters:Internal insert diameterTotal heightTaper can be adjusted by playing with the top and bottom diameters, in combination with the heightI'm open to some additional customisation of the code if you a