Level your Leaning Flatscreen TV!!!

I have a SONY KDL-32CX520 that LEANS LIKE CRAZY.
A Pair of these is the solution.
It needs this 29mm support under each side.

For your specific TV, measure the proper height (Lower side + Higher side /2) from the TV to the tabletop.

Then Scale to Fit, based on 29mm of height (and 71mm long)....
Length doesn't really matter, as you could snip off the rear tab of it was too short.

Example:
If you need 35mm under each side of your TV, then SCALE IT by 121% (35/28=1.21)
If you need 25mm on each side, then scale it by 86.2% (25/29=.862)...
and print!

I paint my PLA matte black, but let it dry in a cool place to avoid shrinkage!