Levitating Hornet

This is a levitating Hornet model from Silksong to go with the Bambu magnetic levitation kit. The model can be printed without AMS and assembled together. Note: There are two versions of the base and lid. One has terrain effects/fuzzy skin to mimic grass and the other is a plain normal base. The one lid with fuzzy skin & terrain affects is printed at an angle in order to get good surface quality for the terrain effect. Remove the magnetic levitation base from its default housing it place it into the new printed shell. Make sure you align it right and push it down onto the 4 pegs in the shell. Attach the touch switch to the front using double sided tape and insert the power connector into the slot at the rear. Snap the lid onto the base. Assemble the flower/seed/vine. There are slots to attach the vine and needle to the lid. I highly recommend gluing these in once you are satisfied with the look. Remove the magnet from its original housing and place it in the screw on cap. Make sure not