LG V60 Bumper Case (Deprecated)

Update: This design is deprecated, I no longer have a V60. It's a pretty basic bumper case that works well enough. I have an unfinished more detailed and nicer case model I worked on in Fusion360, I only had the STL left from my old computer however. That's on my page as well, I think it could be a good starting point for other cases. RIP LG Mobile :(

Simple, yet usable bumper case for LG V60. Please read post-print instructions.

Make sure "Print thin walls" is enabled in Cura, and make sure your bed is perfectly level so the thin back layer corners and button supports print well. I recommend printing at .16mm layer height or lower and 100% infill, with a high print fan cooling speed to bridge gaps better.

All tests I did were with PLA, though I can see something like Nylon or PETG working better. I recommend putting it in the case top first, then bottom left, then bottom right. Case will be easier to take on and off after a few times of doing so.

Done in tinkercad,