License Plate Holder

Most license plate holders I found covered up either or both the name of the state or the motto. I created a recessed section on the back so the 6x12in plate can fit and then I rounded the inside and out of the edges. It is pretty thick so I included the AutoCAD Fusion file so you have full access to the file for personal use. In order to fit it on my build plate, I had to split it into 3 sections. I used the PVA guide for setting supports as default and PVA as interface. However, to assemble it you will need some sort of adhesive. I used superglue. I locked down each end lengthwise on a table and then glued the two middle places into their final space. This was the only way I could keep the ends as tight as possible during assembly. I hope this file is useful to someone.Oh, and I printed on a textured sheet. It's a simple sheet on Amazon where you set the build plate to smooth/high temp. and then it picks up the carbon fiber print. The one I uploaded is a simple textured plate but