Lid for AMS Drying Chock

This is a very rudimentary lid for stustu242's AMS drying chock. I'm currently waiting on ducting to be delivered along with the heater, but wanted to get the bulk of the work complete so it's a straight-forward setup. The last thing I wanted to do was to leave a big hole in the side where moisture and cold air can get inside the AMS, so I developed this relatively thick lid that can cover the port in four different sizes:42mm55mm60mm75mmMore sizes are available upon request. The lid itself is about 3mm thick, with infill, so it's both strong and should retain heat quite well. My advice would be to print this in PETG. Boost Me