Lid for Trashwalker

This is an add-on Lid for Trashwalker - (https://www.thingiverse.com/thing:2978644)

This is a Lid Only, Go to Above Link for the actual Trashwalker.

Can be printed with or without robot eyes.

For the wires coming out of the eyes, filament was slightly heated up and coiled around a small screwdriver.

You will need to scale the lid to the right size in your slicer depending on the size of the Trashwalker / Can you made or are going to make. Eyes are seperate pieces for printing colors / supports. Of course you could just paint them instead. If scaled down or up too much, tolerances may not work for eye parts to fit together.

I originally designed the lid to fit a Trashwalker printed out at ~120%. So measure and or plan the size of your trashwalker and scale the Lid accordingly.

The Lid's dimensions are currently designed at:

Outside Diameter of Lid = 106.6mm
Inside Diameter to lip of Lid = 104.8

Slight sanding or trimming may be needed on Eye parts for good fitm